Cisco CCNA (200-301)
(pearson-200-301-complete)
/ ISBN: 9781644591741
This course includes
Lessons
TestPrep
LiveLab
Mentoring (Add-on)
Cisco CCNA (200-301)
Gain the skills required to pass the Cisco CCNA certification exam with the CCNA (200-301) course and lab. The lab is versatile and delivers hands-on experience, replacing expensive physical labs. The CCNA course comprehensively covers the 200-301 exam objectives and provides knowledge in areas such as Ethernet LANs, command-line interface, LAN switching, networking protocols, subnets, and many more. This CCNA exam guide has learning resources to help you master the exam objectives with real-world scenarios.
The Cisco CCNA certification validates a candidate's knowledge and skills required to install, configure, and operate a small to medium-sized network. This certification provides foundational knowledge in the essentials of networking, security, and automation. The CCNA 200-301 exam is for all support technicians involved in the installation, operation, and verification of Cisco networks.
Lessons
-
66+ Lessons
-
306+ Quizzes
-
542+ Flashcards
-
542+ Glossary of terms
TestPrep
-
102+ Pre Assessment Questions
-
2+ Full Length Tests
-
102+ Post Assessment Questions
-
204+ Practice Test Questions
Lab
-
69+ Network Simulator
Video Lessons
-
20+ Videos
-
02:43+ Hours
- About Cisco Certifications and CCNA
- Course Organization, Lessons, and Appendixes
- Perspectives on Networking
- TCP/IP Networking Model
- Data Encapsulation Terminology
- Review All the Key Topics
- An Overview of LANs
- Building Physical Ethernet LANs with UTP
- Building Physical Ethernet LANs with Fiber
- Sending Data in Ethernet Networks
- Review All the Key Topics
- Wide-Area Networks
- IP Routing
- Other Network Layer Features
- Review All the Key Topics
- Accessing the Cisco Catalyst Switch CLI
- Configuring Cisco IOS Software
- Command References
- Review All the Key Topics
- LAN Switching Concepts
- Verifying and Analyzing Ethernet Switching
- Command References
- Review All the Key Topics
- Securing the Switch CLI
- Enabling IPv4 for Remote Access
- Miscellaneous Settings Useful in the Lab
- Command References
- Review All the Key Topics
- Configuring Switch Interfaces
- Analyzing Switch Interface Status and Statistics
- Command References
- Review All the Key Topics
- Virtual LAN Concepts
- VLAN and VLAN Trunking Configuration and Verification
- Troubleshooting VLANs and VLAN Trunks
- Command References
- Review All the Key Topics
- STP and RSTP Basics
- Details Specific to STP (and Not RSTP)
- Rapid STP Concepts
- Review All the Key Topics
- Understanding RSTP Through Configuration
- Configuring Layer 2 EtherChannel
- Command References
- Review All the Key Topics
- Introduction to Subnetting
- Analyze Subnetting and Addressing Needs
- Make Design Choices
- Plan the Implementation
- Review All the Key Topics
- Classful Network Concepts
- Practice with Classful Networks
- Review All the Key Topics
- Subnet Mask Conversion
- Identifying Subnet Design Choices Using Masks
- Review All the Key Topics
- Defining a Subnet
- Analyzing Existing Subnets: Binary
- Analyzing Existing Subnets: Decimal
- Practice Analyzing Existing Subnets
- Review All the Key Topics
- Installing Cisco Routers
- Enabling IPv4 Support on Cisco Router Interfaces
- Command References
- Review All the Key Topics
- IP Routing
- Configuring IP Addresses and Connected Routes
- Configuring Static Routes
- IP Forwarding with the Longest Prefix Match
- Command References
- Review All the Key Topics
- VLAN Routing with Router 802.1Q Trunks
- VLAN Routing with Layer 3 Switch SVIs
- VLAN Routing with Layer 3 Switch Routed Ports
- Command References
- Review All the Key Topics
- Problem Isolation Using the ping Command
- Problem Isolation Using the traceroute Command
- Telnet and SSH
- Review All the Key Topics
- Comparing Dynamic Routing Protocol Features
- OSPF Concepts and Operation
- OSPF Areas and LSAs
- Review All the Key Topics
- Implementing Single-Area OSPFv2
- Using OSPFv2 Interface Subcommands
- Additional OSPFv2 Features
- Command References
- Review All the Key Topics
- OSPF Network Types
- OSPF Neighbor Relationships
- Command References
- Review All the Key Topics
- Introduction to IPv6
- IPv6 Addressing Formats and Conventions
- Review All the Key Topics
- Global Unicast Addressing Concepts
- Unique Local Unicast Addresses
- Review All the Key Topics
- Implementing Unicast IPv6 Addresses on Routers
- Special Addresses Used by Routers
- Command References
- Review All the Key Topics
- Connected and Local IPv6 Routes
- Static IPv6 Routes
- The Neighbor Discovery Protocol
- Command References
- Review All the Key Topics
- Comparing Wired and Wireless Networks
- Wireless LAN Topologies
- Other Wireless Topologies
- RF Overview
- Review All the Key Topics
- Autonomous AP Architecture
- Cloud-based AP Architecture
- Split-MAC Architectures
- Comparing Wireless LAN Controller Deployments
- Review All the Key Topics
- Anatomy of a Secure Connection
- Wireless Client Authentication Methods
- Wireless Privacy and Integrity Methods
- WPA, WPA2, and WPA3
- Lesson Review
- Review All the Key Topics
- Connecting a Cisco AP
- Accessing a Cisco WLC
- Connecting a Cisco WLC
- Configuring a WLAN
- Review All the Key Topics
- IPv4 Address Types
- Bandwidth and Clock Rate on Serial Interfaces
- Using traceroute to Isolate the Problem to Two Routers
- Troubleshooting Static IPv6 Routes
- Default Routes with SLAAC on Router Interfaces
- Analyzing Collision Domains and Broadcast Domains
- Analyzing Campus LAN Topologies
- Analyzing LAN Physical Standard Choices
- Choosing the Mask(s) to Meet Requirements
- Finding All Subnet IDs
- Mask Design Practice Problems
- Practice Finding All Subnet IDs
- VLSM Concepts and Configuration
- Finding VLSM Overlaps
- Adding a New Subnet to an Existing VLSM Design
- Implementing STP
- Implementing Optional STP Features
- Implementing RSTP
- Command References
- Troubleshooting STP
- Troubleshooting Layer 2 EtherChannel
- Analyzing the Switch Data Plane Forwarding
- Troubleshooting VLANs and VLAN Trunks
- Perspectives on Troubleshooting Routing Protocol Problems
- Interfaces Enabled with a Routing Protocol
- Neighbor Relationships
- Command References
- CCNA 200-301 Exam Topic Order
- Course Lesson Order Versus CCNA 200-301 Exam Topics
- About Cisco Certifications and CCNA
- Course Organization, Lessons, and Appendixes
- TCP/IP Layer 4 Protocols: TCP and UDP
- TCP/IP Applications
- Review All the Key Topics
- IPv4 Access Control List Basics
- Standard Numbered IPv4 ACLs
- Practice Applying Standard IP ACLs
- Command References
- Review All the Key Topics
- Extended Numbered IP Access Control Lists
- Named ACLs and ACL Editing
- Command References
- Review All the Key Topics
- Security Terminology
- Common Security Threats
- Controlling and Monitoring User Access
- Developing a Security Program to Educate Users
- Review All the Key Topics
- Securing IOS Passwords
- Firewalls and Intrusion Prevention Systems
- Command References
- Review All the Key Topics
- Port Security Concepts and Configuration
- Port Security Violation Modes
- Command References
- Review All the Key Topics
- Dynamic Host Configuration Protocol
- Identifying Host IPv4 Settings
- Command References
- Review All the Key Topics
- DHCP Snooping
- Dynamic ARP Inspection
- Command References
- Review All the Key Topics
- System Message Logging (Syslog)
- Network Time Protocol (NTP)
- Analyzing Topology Using CDP and LLDP
- Command References
- Review All the Key Topics
- Perspectives on IPv4 Address Scalability
- Network Address Translation Concepts
- NAT Configuration and Troubleshooting
- Command References
- Review All the Key Topics
- Introduction to QoS
- Classification and Marking
- Queuing
- Shaping and Policing
- Congestion Avoidance
- Review All the Key Topics
- First Hop Redundancy Protocol
- Simple Network Management Protocol
- FTP and TFTP
- Command References
- Review All the Key Topics
- Analyzing Campus LAN Topologies
- Small Office/Home Office
- Power over Ethernet (PoE)
- Review All the Key Topics
- Metro Ethernet
- Multiprotocol Label Switching (MPLS)
- Internet VPNs
- Review All the Key Topics
- Server Virtualization
- Cloud Computing Services
- WAN Traffic Paths to Reach Cloud Services
- Review All the Key Topics
- SDN and Controller-Based Networks
- Examples of Network Programmability and SDN
- Comparing Traditional Versus Controller-Based Networks
- Review All the Key Topics
- SDA Fabric, Underlay, and Overlay
- DNA Center and SDA Operation
- DNA Center as a Network Management Platform
- Review All the Key Topics
- REST-Based APIs
- Data Serialization and JSON
- Review All the Key Topics
- Device Configuration Challenges and Solutions
- Ansible, Puppet, and Chef Basics
- Review All the Key Topics
- Cisco Device Hardening
- Implementing DHCP
- Troubleshooting with IPv4 ACLs
- Implementing HSRP
- Gateway Load Balancing Protocol (GLBP)
- Implementing Simple Network Management Protocol
- Analyzing LAN Physical Standard Choices
- Metro Ethernet
- MPLS VPNs
- CCNA 200-301 Exam Topic Order
- Course Lessons, with Exam Topics Covered in Each
- Managing Cisco IOS Images and Upgrades
- Password Recovery
- Managing Configuration Files
- Command References
Network Simulator
- Obtaining Hardware Information of a Network Adapter
- Obtaining the IP Version of a Network Adapter
- Obtaining Information about Different IP Versions
- Obtaining Information about the Net Firewall Profile
- Getting the TCP Settings
- Getting Information about the Current Connection Statistics of TCP
- Getting Information about the TCP Ports
- Getting Information about the UDP Ports
- Getting the UDP Settings
- Getting Information about the Current Connection Statistics of UDP
- Getting Information about DNS
- Obtaining the ARP Cache
- Obtaining the IP Route Information from the IP Routing Table
- Demonstrating the Difference Between User and Enable (Privileged) Modes
- Enabling Password Security for CLI Access from the Console
- Using the show Command
- Demonstrating the Difference Between CLI Configuration Mode and EXEC Mode
- Configuring Submodes and Contexts
- Listing the Status of the Interfaces in a Switch
- Configuring Basic Passwords
- Configuring SSH in a Router
- Configuring IPv4 on a Switch
- Configuring a Switch to Learn its IP Address with DHCP
- Configuring and Displaying Speed, Duplex, and Description on a Switch
- Removing Various Configuration Settings
- Configuring VLAN
- Enabling and Disabling VLANs on a Switch
- Observing the STP Status
- Configuring a Class A IP Address
- Configuring a Class B IP Address
- Configuring a Class C IP Address
- Listing the Interfaces in a Router
- Configuring a Router
- Verifying IP Addresses on Cisco Routers
- Using the show ip route Command
- Displaying a Router’s IP ARP Table
- Configuring Static Routing
- Configuring Default Routing
- Pinging a Host Using a Router
- Pinging a Host Using PC
- Using the traceroute Command
- Showing Telnet Login From R1 to R2 to View the Status of the Interface on R2
- Adding an IPv6 Address
- Configuring Static IPv6 Addresses on R1 and R2
- Configuring And Verifying NetFlow and NetFlow Data Export and Top Talkers
- Displaying IPv6 Routes
- Rejecting the ipv6 route Command with Link-Local and No Outgoing Interface
- Creating and Applying an ACL at the CLI Using Named Access List Configuration
- Adding to and Displaying a Numbered ACL Configuration
- Using Ettercap for ARP Spoofing
- Spoofing MAC Address
- Performing a DDoS Attack Using cmd
- Using Dig for Passive Reconnaissance
- Using nslookup for Passive Reconnaissance
- Encrypting IOS Passwords with the service password-encryption Command
- Encoding a Password as Type 5 (MD5)
- Creating a New VLAN and Placing Switch Ports into that VLAN
- Configure Interfaces as Trunk Ports
- Configuring Port Fast and Rapid Spanning Tree
- Viewing the IP Address, Mask, and Default Router Settings on Windows
- Viewing the IP Address, Mask, and Default Router Settings on Linux
- Configuring DHCP Snooping
- Disabling the Timestamp and Enabling a Sequence Number in Log Messages
- Configuring Syslog and Viewing Settings on a Router
- Seeing Severity 3 and 5 Messages at the Console and Severity 3 Only in the Buffer
- Setting the Date, Time, Timezone, and Daylight Savings Time
- Configuring a CIDR Based IP Network
- Configuring Network Address Translation
- Showing Cisco IOS File Systems Configuration on a Router
- Showing Small Output from a Switch Command
| What are the prerequisites for this exam? | There is no formal requirements for taking the new exam. However, Cisco recommends that the candidate should have:
|
|---|---|
| What is the exam registration fee? | USD 300 |
| Where do I take the exam? | Pearson VUE |
| What is the format of the exam? |
|
| How many questions are asked in the exam? | The exam contains 100- 120 questions. |
| What is the duration of the exam? | 120 minutes |
| What is the passing score? | 800-850 (on a scale of 300-1000) |
| What is the exam's retake policy? | The policies for retaking exams are as follows:
|
| Where can I find more information about this exam? | To know more about the 200-301, click here. |
| What are the career opportunities after passing this exam? |
|
×
